相信大家在使用卷帘门的时候都会遇到同样的一个问题，就是卷帘门遥控器怎样配。常用的卷帘门遥控器一般分为发射和接收两个部分。下面济南卷帘门小编来讲讲关于遥控卷帘门遥控器的相关事项吧。

I believe that everyone will encounter the same problem when using the roller shutter door, that is, how to match the remote controller of the roller shutter door. The commonly used remote controller for roller shutter door is generally divided into two parts: transmitting and receiving. Now let's talk about the matters related to the remote control of the roller shutter door.

就卷帘门遥控器的接收部分来看，可以分为超外差和超再生两种方式。超再生解调电路也被称为超再生检波电路，实际上就是在间歇振荡状态下的再生检波电路．

As far as the reception part of the roller shutter remote controller is concerned, it can be divided into two modes: superheterodyne and super regeneration. Super regenerative demodulation circuit is also called super regenerative detection circuit, which is actually a regenerative detection circuit under intermittent oscillation

卷帘门遥控器配置中常用的载波频率为433mHz和315mHz，遥控器使用的载波频率是规定的开放频段，在这一频段内，发射功率小于10mW和覆盖范围小于100m，只要不超过本单位范围，都不必经过“无线电管理委员会”审批可以自由使用。

The common carrier frequencies used in the configuration of the roller shutter door remote controller are 433mHz and 315mHz. The carrier frequencies used in the remote controller are the open frequency band specified by the state. In this band, the transmission power is less than 10mW and the coverage is less than 100m. As long as it does not exceed the scope of the unit, it can be freely used without the approval of the "Radio Management Committee".

在卷帘门遥控器的配置上可以分为红外遥控器和无线遥控器，它们是由于不同的载波来说的，红外遥控器是利用红外线来进行传送控制信号的，特点是具有方向性、中间不能有阻挡、距离一般都不会超过7米、同时不会受电磁干扰，电视机遥控器采用的比较多的就是红外遥控器。

In terms of the configuration of the roller shutter door remote controller, it can be divided into infrared remote controller and wireless remote controller. They are due to different carriers. The infrared remote controller uses infrared to transmit control signals. It is characterized by directionality, no blocking in the middle, the distance generally does not exceed 7 meters, and it is not subject to electromagnetic interference. The infrared remote controller is widely used in TV remote controllers.

配卷帘门遥控器操作方法

Operating method of remote controller equipped with roller shutter door

1、清码

1. Clear code

同时按下遥控器上排的两个按键指示灯闪一次后约2秒后快闪即表示成功。之后按遥控器四个按键指示灯仅闪一下后熄灭。

Press the two buttons on the upper row of the remote control at the same time, and the indicator lights flash about 2 seconds later, indicating that the removal is successful. After clearing, press the four buttons on the remote control to turn off the indicator after flashing once.

2、对拷

2. To copy

将原遥控器与对拷遥控器并排摆放（右手拿快拷遥控器），同时按下两个遥控器任意按键，对拷型遥控器指示灯快闪即表示复制成功。仅1秒即可复制成功。依次按相同方法，将其它三个按键对拷上。

Place the original remote control and the copy remote control side by side (hold the copy remote control with the right hand), press any key of the two remote controls at the same time, and the copy remote control indicator flashes to indicate that the copy is successful. The copy is successful in only 1 second. Press the same method in turn to copy the other three keys.

3、恢复

3. Restore

若误操作掉有用代码后，在没有重新拷贝其他遥控器之前可同时按下遥控器下排两个按键2秒后指示灯快速闪烁则恢复。

If the useful code is cleared by misoperation, the indicator lamp will flash quickly after pressing the two buttons on the lower row of the remote controller for 2 seconds before copying other remote controllers again.

一般在安装卷帘门的时候是配备遥控器的，也可以单独安装遥控器，这些小常识可以多参考一下的。对于了解配卷帘门遥控器这个问题有很好的帮助，希望能让大家有所了解。关注我们http://xl0475.com，了解更多！

Generally, remote control is equipped when installing roller shutter doors, or it can be installed separately. You can refer to these tips. It is very helpful to understand the problem of remote control for roller shutter door, and I hope it can let you know something about it. Follow us http://xl0475.com , learn more!