快盈11v

快盈11v网站 在线留言 联系我们

服务咨询热线

151 6888 2846

热门关键词: 水晶折叠门 水晶卷帘门 抗风卷帘门

行业新闻

首页>>新闻资讯>>行业新闻电动卷帘门电机故障及检测方法
联系我们
快盈11v

联系人:林经理

电话:151 6888 2846

邮箱:快盈11v527800164@qq.com

地址:快盈11v济南市历下区化纤厂路8号3号楼101号

电动卷帘门电机故障及检测方法

来源:http://xl0475.com 日期:2022-02-17 发布人:
电压测量法是更常用的检修方法之一,就是通过测怀疑点电压是否正常来判断故障部位和故障原因。比如在检修电机不转、而仪表盘亮故障时,可通过测控制器的供电电压和输出电压判断故開部位:再比如检修电机转速不正常故障时,可通过测调速转把输出的控制电压来判断它是否正常。
Voltage measurement method is one of the most commonly used maintenance methods, which is to judge the fault location and cause by measuring whether the voltage at the suspected point is normal. For example, when the motor does not rotate and the instrument panel is on, the fault opening position can be judged by measuring the power supply voltage and output voltage of the controller; for example, when the motor speed is abnormal, whether it is normal can be judged by measuring the control voltage output by the speed regulating handle.
电阻测量法
Resistance measurement method
作用
effect
电阻测量法是更主要的检修方法之。该方法就是通过测怀疑的线路、 器件的阻值是否正常,来判断故障部位和故障原因。比如在检修电机运转不正常故障时,可通过测电机3个绕组的阻值,判断它是否匝间短路或断路,而检修无刷电机时,测它的3条传感信号输出线对地和5V供电之间的阻值时,可判断霍尔元件是否损坏:再比如在整车无电故障时,还可测量保险管、电源锁和供电线路是否断路,控制器是否短路等。
Resistance measurement is one of the most important maintenance methods. This method is to judge the fault location and cause by measuring whether the resistance value of suspected lines and devices is normal. For example, when repairing the abnormal operation of the motor, you can judge whether it is short circuit or open circuit between turns by measuring the resistance of three windings of the motor. When repairing the brushless motor, you can judge whether the hall element is damaged by measuring the resistance between its three sensing signal output lines to the ground and 5V power supply. For example, when there is no power failure of the whole vehicle, you can also measure the fuse Whether the power lock and power supply line are open circuit, whether the controller is short circuit, etc.
济南电动卷帘门
在检测线路、电源锁等器件是否断路时,可采用万用表“蜂鸣”档(有的数字万用表该功能附加在“二极管”档上)进行测量,若万用表发出鸣叫声,说明线路正常:若没有鸣叫声,说明线路已断:若有时鸣叫有时无声,说明线路接触不良。
When detecting whether the circuit, power lock and other devices are open circuit, the "beep" gear of the multimeter can be used for measurement (the function of some digital multimeter is attached to the "diode" gear). If the multimeter emits a beep, it indicates that the circuit is normal; if there is no beep, it indicates that the circuit is disconnected; if it sometimes beeps and sometimes silent, it indicates that the circuit is in poor contact.
分类
classification
电阻测量法有在路检测和非在路检测两种。在路检测法就是在线路上或电路板上直接检测元件的阻值,不在路检测就是单独检测该元件阻值。
There are two kinds of resistance measurement methods: on-line detection and off-line detection. The on-line detection method is to directly detect the resistance value of the component on the line or circuit board, and the off-line detection is to detect the resistance value of the component separately.

阅读/ Recommended reading

一、查看线路1、 View routes就是在使用这类产品的时候,如果出现了故障,那么应该注意的就是对于整个产品的情况的检查与了解,因为有的时候可能出现的问题并不是整个门真...

防火卷帘门分几种类别? 2024-06-06
防火卷帘门对于企业的使用有哪些? 2024-06-09
济南卷帘门:卷帘门的工作原理以及工作过程 2024-05-23
济南卷帘门:如何调节卷帘门限位? 2024-05-17
济南卷帘门:电动卷帘门的优势有哪些? 2024-05-15
济南卷帘门:电动卷帘门遥控器相关知识介绍 2024-05-11
济南卷帘门:卷帘门的用处有哪些? 2024-05-08
防火卷帘门保护装置特点 2024-04-18